Description
WORKS AFTER COMPLETION OF APPLICATION
– Immediately after full foam hardening, it should be secured against exposure to UV rays by using e.g. plaster or paints, acrylic, silicon.
– After completion of work, the applicator should be thoroughly cleaned. To this end, a can with the cleaner should be screwed on the applicator and its trigger should be pushed until the moment, when clean fluid starts flowing out.
REMARKS / RESTRICTIONS
DOOR AND WINDOWS FITTING WITHOUT USING MECHANICAL COUPLING IS FORBIDDEN. LACK OF MECHANICAL COUPLINGS MAY CAUSE DEFORMATION OF THE MOUNTED ELEMENT.
– The curing process is dependent on temperature and humidity. The decrease in ambient temperature within 24 h after the application below the minimum application temperature can affect the quality and / or correctness of the seal.
– Hurried attempts at preliminary treatment may cause irreversible changes in foam structure and its stability and may affect deterioration of foam utility parameters.
– The foam displays lack of adhesion to polyethylene, polypropylene, polyamide, silicone and Teflon.
– Fresh foam should be removed with polyurethane foam cleaner.
– Hardened foam may only be removed mechanically (e.g. with a knife).
– Quality and technical condition of used applicator affect the parameters of final product.
– The foam should not be used in spaces without access of fresh air and poorly ventilated or in places exposed to direct sunlight.
– The manufacturer recommends using strip foam once (at one go), because in case of foam drying in the applicator, the future use may be impossible.
Reviews
There are no reviews yet.